search query: @instructor Nokelainen, Tero / total: 3
reference: 1 / 3
« previous | next »
Author: | Lindroos, Mauri |
Title: | Laminated veneer lumber (LVL) -puutuotteen tuotantoparametrien optimointi |
The optimization of production parameters of laminated veneer lumber (LVL) wooden product | |
Publication type: | Master's thesis |
Publication year: | 2011 |
Pages: | 66 s. + liitt. 11 Language: fin |
Department/School: | Puunjalostustekniikan laitos |
Main subject: | Puutekniikka (Puu-28) |
Supervisor: | Kairi, Matti |
Instructor: | Antikainen, Toni ; Nokelainen, Tero |
OEVS: | Electronic archive copy is available via Aalto Thesis Database.
Instructions Reading digital theses in the closed network of the Aalto University Harald Herlin Learning CentreIn the closed network of Learning Centre you can read digital and digitized theses not available in the open network. The Learning Centre contact details and opening hours: https://learningcentre.aalto.fi/en/harald-herlin-learning-centre/ You can read theses on the Learning Centre customer computers, which are available on all floors.
Logging on to the customer computers
Opening a thesis
Reading the thesis
Printing the thesis
|
Location: | P1 Ark Aalto 2349 | Archive |
Keywords: | laminated veneer lumber buttjoint glue spread hot press modulus of rupture modulus of elasticity LVL puskujatkos liimanlevitys kuumapuristus murtolujuus kimmokerroin |
Abstract (eng): | A buttjoint is a joint between two veneers which are set against each other so that there is a small gap between them. The aim of the research was to examine, how adding buttjoints affects the strength properties of laminated veneer lumber. In addition glue spread was tried to cut down because of cost savings and hot press time was tried to make shorter so that production capacity would increase. All the test drives were made in the production lines of a LVL-factory, so all the normal conditions and interferences were part of the studies. It was also followed during the test drives if the changes in production parameters affect somehow to the fluency of production lines. It was seen from the tests that it is possible to reduce glue spread and hot press time in different thicknesses. |
Abstract (fin): | Puskujatkos on viilujen välinen päittäisliitos, jossa kaksi viilua ladotaan vastakkain jättäen pieni väli niiden väliin. Työssä pyrittiin selvittämään, millainen vaikutus eri puskujatkosmäärillä on LVL:n lujuusominaisuuksiin. Lisäksi liimanlevitystä pyrittiin vähentämään kustannussäästöjen vuoksi ja kuumapuristusaikaa pyrittiin lyhentämään eri paksuuksilla tuotantokapasiteetin parantamisen vuoksi. Kaikki koeajot tehtiin LVL-tehtaan tuotantolinjoilla, jolloin mukana olivat kaikki normaalit olosuhteet ja häiriöt. Koeajoissa myös seurattiin, vaikuttavatko tuotantoparametrien muutokset jollakin tavoin tuotantolinjojen sujuvuuteen. Testeissä havaittiin muun muassa, että liimanlevitystä ja kuumapuristusaikaa on mahdollista vähentää eri paksuuksilla. |
ED: | 2011-05-11 |
INSSI record number: 42054
+ add basket
« previous | next »
INSSI